OUT PATIENT(NON-INVASIVE)

Diagnostic outpatient procedures,

such as the one listed below can detect medical conditions early to prevent cardiovascular complications in the future, thus placing greater emphasis on proper cardiac care. Early detection of coronary, carotid, renal and peripheral artery blockages are extremely important in cardiovascular disease prevention.

OUTPATIENT SERVICES INCLUDE:

  • Blood tests (Lipids, C-Reactive Protein, Homocysteine)
  • Stress Test
  • Ambulatory blood pressure Monitor
  • Ambulatory Holter Monitor
  • Echocardiogram
  • Stress Echocardiogram
  • Nuclear Stress Testing
  • Carotid Duplex Ultrasound
  • Vascular Duplex Ultrasound
BLOOD TESTS ( LIPIDS, C-REACTIVE PROTEIN, HOMOCYSTEINE )

How do I prepare for the Test?

The only requirement is that the patient wear loose-fitting clothes. Buttons down the front of a shirt or blouse is preferable. This makes it convenient to apply the EKG electrodes, and also comfortably carry the monitor in a relatively discreet manner

How is the Test Performed?

The chest is cleansed with an alcohol solution to ensure good attachment of the sticky EKG electrodes. Men with hairy chest may require small areas to be shaved. The EKG electrodes (circular white patches on the left) are applied to the chest. Thin wires are then used to connect the electrodes to a small tape recorder. The tape recorder is secured to the patient’s belt or it can be slung over the shoulder and neck with the use of a disposable pouch. The recorder is worn for 24 hours and the patient is encouraged to continue his or her daily activities. To avoid getting the setup wet and damaging the recorder, the patient will not be able to shower for the duration of the test. A diary or log is provided so that the patient can record activity (walking the dog, upset at neighbor, etc.) and symptoms (skipped heartbeats, chest discomfort, dizziness, etc.) together with the time. The Holter monitor has an internal clock which stamp the time on the EKG strips. These can be used to correlate the heart rhythm with symptoms or complaints. After 24 hours, the Holter monitor needs to be returned to the laboratory. This can be removed by the staff. However, if you live out of town or need to take a shower before leaving the house, the monitor can be disconnected from the electrodes and sent back to the laboratory, together with the completed diary.

After returning the Holter Monitor to the doctor’s office, satellite clinic or hospital lab, the tape is removed from the recorder and scanned by a technician. Multiple EKG strips are recorded on paper together with a computer-generated summary that provides details about the patient’s heart rate and rhythm during the recording. This information is then provided to your doctor.

How long does it take?

It takes approximately 10 to 15 minutes to apply the monitor and less than 5 minutes to remove it. The patient will also receive directions. Many monitors are also equipped with an “event” button. Pressing the button during a symptom (dizziness, for example) will help the technician print an ECG from that precise time.

How safe is the test?

Holter monitoring is extremely safe and no different than carrying around a small tape recorder for 24 hours. Some patients are sensitive to the electrode adhesive, but no serious allergic reactions are known

When will I get the results?

The report is provided to the physician, together with multiple EKG strips after the tape has been scanned by the technician. If the technician sees a rhythm that is life-threatening or potentially dangerous the physician is informed immediately. Otherwise, it may take a few days before you get the official results from your physician’s office. At that time, you may also receive additional recommendations based upon the results of the test. For example, a pacemaker may be recommended if a patient has blackouts and the Holter monitor shows a seriously slow heart beat during the test.

TRANSESOPHAGEAL ECHO (TEE )